Нужна прошивка для Dahua XVR4108HS-S2

Статус
Закрита.
Я

ЯрРа

Active member
Доброго времени суток. Ищу прошивку на сей девайс. Скачал пару но они не подходят
 
Я

ЯрРа

Active member
DH_XVR5x04-S2_Eng_P_V3.218.0000002.5.R.190301.bin Вот эта заливается по FTP но результата дальше нет.
 
Я

ЯрРа

Active member

U-Boot 2010.06-svn2982 (Dec 29 2017 - 15:49:20)

Check Flash Memory Controller v100 ... Found
SPI Nor(cs 0) ID: 0xc8 0x40 0x18
Block:64KB Chip:16MB Name:"GD25Q128"
SPI Nor total size: 16MB
In: serial
Out: serial
Err: serial
chip type hi3520dv300
===============================================
DPLL:400Mhz DDR:1600Mhz
APLL:800Mhz VPLL0:162Mhz
===============================================
phy id:0x1cc816
nice find PHY RTL8201 on higmac
hwid_gpio_val=0x3E
hwid_gpio_val=0x3E
hwid_gpio_val=0x3E
hwid_gpio_val=0x3E
hwid_gpio_val=0x3E
find_inode failed for name=hwidconfig
hwid_gpio_val=0x3E
find_inode failed for name=hwidconfig
Hit any key to stop autoboot: 0
Loading Kernel Image ... OK
OK

Starting kernel ...

Uncompressing Linux... done, booting the kernel.

 
Я

ЯрРа

Active member
Команда dh_keyboard 0 как и PRINT не проходит. Обновлял двумя путями по команде TFTP (uImage- имя прошивки) и RUN UP (update.img). Он вроде взял скачал в себя я ему следом RESET но эффекта ноль. ПО команде usb с флешки толкал. Интересно что данную прошивку я через флешку при загруженном регистраторе на подобной модели толкал. И русификатор под неё есть.
 
Я

ЯрРа

Active member
hisilicon # run up
ETH0: PHY(phyaddr=0, rmii) link UP: DUPLEX=FULL : SPEED=100M
MAC: 14-A7-8B-D1-34-61
TFTP from server 192.168.0.15; our IP address is 192.168.0.222
Download Filename 'update.img'.
Download to address: 0x82000000
Downloading: # [ Connected ]
################################ [ 1.000 MB]
################################ [ 2.000 MB]
################################ [ 3.000 MB]
################################ [ 4.000 MB]
################################ [ 5.000 MB]
################################ [ 6.000 MB]
################################ [ 7.000 MB]
################################ [ 8.000 MB]
################################ [ 9.000 MB]
################################ [10.000 MB]
################################ [11.000 MB]
################################ [12.000 MB]
################################ [13.000 MB]
################################ [14.000 MB]
####
done
Bytes transferred = 14835642 (e25fba hex)
close frondboard!
Bad Magic Number
flwrite error 1!
connect frondboard!
resetting ...

и после перезагрузки сюда ломиться

TFTP from server 192.168.254.254; our IP address is 192.168.1.108; sending through gateway 192.168.1.1
Download Filename 'ID_3L05142PAZ27296.txt'.
Download to address: 0x82000000
Downloading: T T T
Retry count exceeded; starting again
Loading Kernel Image ... OK
OK
 
Я

ЯрРа

Active member
U-Boot 2010.06-svn2982 (Dec 29 2017 - 15:49:20)

Check Flash Memory Controller v100 ... Found
SPI Nor(cs 0) ID: 0xc8 0x40 0x18
Block:64KB Chip:16MB Name:"GD25Q128"
SPI Nor total size: 16MB
In: serial
Out: serial
Err: serial
chip type hi3520dv300
===============================================
DPLL:400Mhz DDR:1600Mhz
APLL:800Mhz VPLL0:162Mhz
===============================================
phy id:0x1cc816
nice find PHY RTL8201 on higmac
hwid_gpio_val=0x3E
hwid_gpio_val=0x3E
hwid_gpio_val=0x3E
hwid_gpio_val=0x3E
hwid_gpio_val=0x3E
find_inode failed for name=hwidconfig
hwid_gpio_val=0x3E
find_inode failed for name=hwidconfig
Hit any key to stop autoboot: 0
hisilicon # setenv dh_keyboard 0
hisilicon # saveenv
hisilicon # reset
resetting ...


U-Boot 2010.06-svn2982 (Dec 29 2017 - 15:49:20)

Check Flash Memory Controller v100 ... Found
SPI Nor(cs 0) ID: 0xc8 0x40 0x18
Block:64KB Chip:16MB Name:"GD25Q128"
SPI Nor total size: 16MB
In: serial
Out: serial
Err: serial
chip type hi3520dv300
===============================================
DPLL:400Mhz DDR:1600Mhz
APLL:800Mhz VPLL0:162Mhz
===============================================
phy id:0x1cc816
nice find PHY RTL8201 on higmac
hwid_gpio_val=0x3E
hwid_gpio_val=0x3E
hwid_gpio_val=0x3E
hwid_gpio_val=0x3E
hwid_gpio_val=0x3E
find_inode failed for name=hwidconfig
hwid_gpio_val=0x3E
find_inode failed for name=hwidconfig
Hit any key to stop autoboot: 0
Loading Kernel Image ... OK
OK

Starting kernel ...

Uncompressing Linux... done, booting the kernel.


Единственное что вижу -

find_inode failed for name=hwidconfig
hwid_gpio_val=0x3E
find_inode failed for name=hwidconfig

Плата D1718 41_168 80176883
 
Я

ЯрРа

Active member
Вот вновь скачал прошивку:


Hit any key to stop autoboot: 0
hisilicon # usb
usb_stor_get_info->1489,blksz:512
Interface: USB
Device 0: Vendor: Generic Rev: 1.11 Prod: Mass-Storage
Type: Removable Hard Disk
Capacity: 1920.0 MB = 1.8 GB (3932160 x 512)
Partition 0: Filesystem: FAT16 "NO NAME "
reading u-boot.bin.img

upgrade file: u-boot.bin.img found
close frondboard!
Header CRC Checking ... OK
Data CRC Checking ... OK
Image Name: hi3520Dboot
Image Type: ARM Linux Standalone Program (gzip compressed)
Data Size: 312428 Bytes = 305.1 KiB
Load Address: a0000000
Entry Point: a0050000
img_addr 0x82000000 write to: 0xa0000000
write : 100%
done
reading update.img

upgrade file: update.img found
close frondboard!
Bad Magic Number
flwrite error 1!
do_usb_img_update failed
 
Статус
Закрита.
Зверху